Guía de instalación de SoiLite

The SoiLite is available in two configurations:

SoiLite i4 Model – attaches directly to the rear of the LW Scientific i4 microscope.

SoiLite Desk Model – sits on the lab bench and connects via a flexible gooseneck to any model microscope.

Both models use the same EasyGrip attachment system to connect the ring light illuminator to microscope objectives.

What's Included

SoiLite Controller Unit (Desk Mount or i4 Rear-Mount)
Ring light with gooseneck
12vDC / 1amp power adapter
2 mounting screws (only with i4 Rear-Mount)

Setup Instructions - i4 Rear-Mount Controller

Using a screwdriver, remove the two existing screws from the rear of the microscope body.

Removing existing screws from rear of LW Scientific i4 microscope for SoiLite installation

Install the SoiLite rear-mount controller using the longer screws that were included with the controller. When installing screws into the rear of the i4, ensure they are kept level and horizontal. Avoid inserting them at an angle to ensure proper thread alignment. Tighten securely, but do not overtighten.

Installing SoiLite i4 rear-mount controller onto microscope with included mounting screws

SoiLite i4 controller securely mounted to rear of LW Scientific microscope

A close-up view of a screwdriver inserting a screw horizontally into the rear panel of the i4, showing perfectly level alignment with the screw hole.

Install the gooseneck onto the controller, ensuring to align the tab into the groove, then tighten the ring nut securely.

Tightening ring nut to secure SoiLite gooseneck to i4 controller

Aligning SoiLite gooseneck tab into controller groove for proper installation

Fully installed SoiLite gooseneck attached to i4 rear-mount controller

Plug the 12vDC power adapter into the controller.

Turn the unit on by turning the dimmer knob to the right. Increase the brightness as needed.

Turning on SoiLite by rotating dimmer knob to adjust brightness on i4 controller

Setup Instructions - Desk Controller

Install the gooseneck onto the controller, ensuring to align the tab into the groove, then tighten the ring nut securely.

Tightening ring nut to secure SoiLite gooseneck to desk controller

Fully installed SoiLite gooseneck attached to desk controller

Plug the 12vDC power adapter into the controller.

Turn the unit on by turning the dimmer knob to the right. Increase the brightness as needed.

Turning on SoiLite by rotating dimmer knob to adjust brightness on desk controller

Installing the SoiLite

The SoiLite EasyGrip allows the illuminator to attach directly to microscope objectives.

Lower the stage slightly and rotate the desired objective to the side.

Hold the SoiLite by the blue EasyGrip lever. Press the lever to open the clamp.

Holding SoiLite ring light by blue EasyGrip lever for microscope objective attachment

Pressing SoiLite EasyGrip lever to open clamp for microscope objective

Position the SoiLite around the chosen objective (10x, 40x, etc.). Release the EasyGrip to secure it.

Positioning SoiLite ring light around 10x or 40x microscope objective lens

Releasing SoiLite EasyGrip lever to secure ring light onto objective

SoiLite ring light securely attached to microscope objective with EasyGrip

Rotate the objective with SoiLite back into position above the slide.

Rotating microscope objective to the side for SoiLite installation

Rotating microscope objective with attached SoiLite back to viewing position above slide

Position the SoiLite higher or lower on the objective for the desired lighting effect.